MAGracing Forum

Her is a internal view of a fully mounted CH01-24-ReFb ( my third option for the chassis ).

REar motor FrontBattery. with 2 options for placing the receiver ( for chassis from 100mm and larger.).
I found some servos have very short wires.

Also mounted is my lapcounter module and all the rest.

Any thoughts ?

What is the wheelbase of the chassis in the photo?
What is the distance between the front wheels, when measured from the outside of one to the outside of the other?
Is the wheelbase adjustable?

This is a105 mm WB. It is not adjustable, but I print them to spesific WB.
https://id4u.no/butikk#!/magracing-1-0x ... -wheelbase

Front wheel track with is 67mm. Based on 7mm broad wheels.
Rear wheel uses a 70mm axle. and with 13mm broad rears totals ca 77mm.

Hello,

Very nice realization. I love the wheels in particular which are not the same size.

I'm also testing some gimmics.

By printing the wheels 1st mm in 'alloy' collor theen white the disk looks nice. And printing the wheel-knucle in contrast color - woala - we got brake calipers at least on front wheels..

Super neat, Kim. It will be a big help in building the chassis I just received!
I am about to order the Tx/Rx you mentioned (as noted below) but haven't been able to determine what the best ESC would be for that receiver and the motor you included in my chassis order. What would you suggest?

Flysky FS-GT3C GT3C Transmitter Remote Control With GR3E Receiver For RC Car

Thanks,
David

viewtopic.php?t=792

Trying to keep answers thins in the right places.

There we are.