Drawing / routing the RaceLine. The helping arms.
Posted: Sat 14. Nov 2020 15:42
Doing it by hand pose some problems.
After some thought I checked the internet to see if he agreed with me.
And yes we where on the same track.
Still missing the router/pen connection but my 3D printed ellipse arms are working.
If I might say, quite fascinating to watch.
I put on some tape to make it easier to see.
I found that if using Scalextric tracs starting and ending in the thin groves where the power-lead where would be a good choice.
https://youtu.be/BvvLBOvMaec
https://youtu.be/TX0ULq_FtvQ
After some thought I checked the internet to see if he agreed with me.
And yes we where on the same track.
Still missing the router/pen connection but my 3D printed ellipse arms are working.
If I might say, quite fascinating to watch.
I put on some tape to make it easier to see.
I found that if using Scalextric tracs starting and ending in the thin groves where the power-lead where would be a good choice.
https://youtu.be/BvvLBOvMaec
https://youtu.be/TX0ULq_FtvQ