KK-CH01-24scale-New-motorpod

Tips and tricks about building a car. painting it a making it run smooth.
Post Reply
kiklo
Administrator
Posts: 485
Joined: Mon 9. Nov 2015 11:49
Location: Norway
Contact:

KK-CH01-24scale-New-motorpod

Post by kiklo »

Not totally happy with my old barrel motorpod I have done some changes.
Now a C shaped motorcontainer with a sliding mechanism giving 2-3 mm play/adjustment.
The C is strong enough to hold the motor thight and there are 'fences' to keep it from sliding sideways.
Should make it easier to use different gears.
The pod snaps inn and slide into place.
motorpod.jpg
motorpod.jpg (61.18 KiB) Viewed 4406 times
motorpod.PNG
motorpod.PNG (223.24 KiB) Viewed 4406 times
Racing Regards

Kim K.
kiklo
Administrator
Posts: 485
Joined: Mon 9. Nov 2015 11:49
Location: Norway
Contact:

Re: KK-CH01-24scale-New-motorpod

Post by kiklo »

Then I deceided to make a RearEngine version as well. (Motor behind the axle.) Should match a 911, Renault Alpine, NSU, VW Beetle etc.
IF you like them tailhappy....
re.PNG
re.PNG (145.61 KiB) Viewed 4385 times
Racing Regards

Kim K.
kiklo
Administrator
Posts: 485
Joined: Mon 9. Nov 2015 11:49
Location: Norway
Contact:

Re: KK-CH01-24scale-New-motorpod

Post by kiklo »

RE2.jpg
RE2.jpg (55.38 KiB) Viewed 4382 times
Racing Regards

Kim K.
goatdope
Posts: 37
Joined: Tue 28. Jan 2014 19:53
Location: Lansing, Illinois, USA

Re: KK-CH01-24scale-New-motorpod

Post by goatdope »

Hi Kim, I was looking at your new "motor pod" 1/24/scale. I admire your talent for functional design . That really looks good.
the rear motor setup is pretty cool also. I like the rear axle bushings. Some of my older mag racer chassis have excessive clearence
in the axle holes due to wear. good job, Ken
kiklo
Administrator
Posts: 485
Joined: Mon 9. Nov 2015 11:49
Location: Norway
Contact:

Re: KK-CH01-24scale-T30-T36-T40

Post by kiklo »

Fitting T40 or T36 will give you a greater choice of ajusting speed to mach scale/track.
T40.jpg
T40.jpg (81.54 KiB) Viewed 4340 times
Racing Regards

Kim K.
Post Reply