To fix my broken steering.
I drilled out the center to 6 mm.
Created a 'bolt', spacer and nut. 3 STL files.
Using a friends 3D printer. Had to sand parts to a snug fit.
Modified the controller with the extra retainer hole to get the spacer to stay put.
(Used drilled the small hole as a guide before I did the 5 mm.)
Added some pictures. May have to ceate a new post to be able to add the STL.
Controller steering axel fix.
Controller steering axel fix.
- Attachments
-
- parts.JPG (82.29 KiB) Viewed 40454 times
-
- inside.JPG (77.75 KiB) Viewed 40454 times
Racing Regards
Kim K.
Kim K.
Re: Controller steering axel fix.
Here the STL's are. Have fun.
- Attachments
-
- magracing_controller_steering_support_spacer.stl
- (26.15 KiB) Downloaded 2244 times
-
- magracing_controller_steering_axel_retainer.stl
- (9.46 KiB) Downloaded 2282 times
-
- magracing_controller_steering_axel.stl
- (15.34 KiB) Downloaded 2161 times
Racing Regards
Kim K.
Kim K.
Re: Controller steering axel fix V2.
Just thought I'd do an update. The problem is still the same. I think this is better fix.
Making a new attachment for the broken steering wheel and twisting the knob 180 as a snap on. You may have to sand a bit depending on your printer.
Here is a pic of the file you can use. The small version is the better I think a it will not split at layers printed that way.
Making a new attachment for the broken steering wheel and twisting the knob 180 as a snap on. You may have to sand a bit depending on your printer.
Here is a pic of the file you can use. The small version is the better I think a it will not split at layers printed that way.
- Attachments
-
- Id4u-MagRacing-steering-knob.stl
- (169.42 KiB) Downloaded 1873 times
Racing Regards
Kim K.
Kim K.
Re: Controller steering axel fix. Need some ?
If you don't have access to a 3D printer nearby pm me if you want me to send to you.
It will only cost you postage and 2 $ for material
It will only cost you postage and 2 $ for material
Racing Regards
Kim K.
Kim K.