magnet change
-
- Posts: 456
- Joined: Thu 4. Dec 2014 09:53
- Location: cologne
Re: magnet change
hi all magracers, i found out something very interesting new. i pushed out the sidemagnets and glued one of them in the middle of the frontaxle, right above the guidemagnet, so that they pull against the other. effect is, the highest magnetforce is, wen wheels are straight. so you eliminate the frontend shimmy complete. if you turn , you make the force smaller, so the steering is working much better. i think that would be interesting to wes, because its a general change to make the cars better.( and you only need one magnet. ) if it is to strong ,use spacers. hope it will work as good by you as on my conditiones.
-
- Posts: 456
- Joined: Thu 4. Dec 2014 09:53
- Location: cologne
Re: magnet change
i found out this while working on my 1:24 cars. i am getting nearer to run them smooth, but its a lot of testing . the glue gets hard to slow greetings from cologne markus
-
- Posts: 456
- Joined: Thu 4. Dec 2014 09:53
- Location: cologne
Re: magnet change
best place is not above, in front of the axle. magnet flips there by itself, only glue in the middle.
Re: magnet change
OK Marcus, I will try this tomorrow!
-
- Posts: 456
- Joined: Thu 4. Dec 2014 09:53
- Location: cologne
Re: magnet change
hi all, on some cars i had to reduce the steering power, because they run out of the wire wen steering. took out one of the cardspacers at the steeringcoil and it works perfect. must say, i drive with 5x3 guidemagnets.