MAGracing Forum

i had a problem with two points on my track, were two lines go in one in a curve. i laid the outerline in one piece , and the innerline a few cm side by side. but were the innerline ends the guidemagnet gets a little shock to the outside, enough to loose the wire. that was shit, to loose the car in every round at this point if you are only a little bit to fast. i installed a 5 cm piece of wire on the inside of this points to make the magnetforce higher .problem elemienated.

sounds like a good idea to fix the problem, do you have a photo of that too?

i will make

hope you can see anything

i had to built a small piece, because in my track you cant see it.click on the foto and it will be bigger i hope.