Help !

Tell us about your track, post a picture from the track together with description

Where is the track located, and is it open for visitors like a club track,
WesR
Posts: 371
Joined: Fri 21. Dec 2012 17:37

Re: Help !

Post by WesR »

We were in Bergerac and Pauillac (but not Cadillac!) in Sept. Excellent!
But we didn't see Sylvain or Biscarosse. Probably because they are in the Landes on the SW coast (I just Googled it!) Looks nice there too Lasp.
Re. the dremel saw and lane change plates, I cannot help because this is the reason
I never used one. I guess you have to rout a larger area than the plate but it must be flat. You just have to experiment.
Good luck.
User avatar
Keld
Administrator
Posts: 417
Joined: Thu 13. Dec 2012 19:06
Location: Copenhagen, Denmark
Contact:

Re: Help !

Post by Keld »

when I use the dremel method, I don't use the plates, look at my video and pictures again.
/Keld
Pussywagon
Posts: 29
Joined: Mon 25. Nov 2013 12:48
Location: Biscarrosse France

Re: Help !

Post by Pussywagon »

Hello!
In fact it is necessary to double the wire on 4 cm to replace lane change ?? Isn't it ? :roll:

Sylvain
User avatar
Kellerkind
Posts: 35
Joined: Fri 29. Nov 2013 22:34
Location: Neustadt Southwest Germany

Re: Help !

Post by Kellerkind »

Hello,

you might just cut two little slots both sides of your future bed with a japansaw, take out the wood inbetween wit a sharp knife, even a screwdriver works. Put some filler into the hole and put the metalplate just inside to be flush with the surface. Sand off the overflow and maybe correct with some more filler. Take care to have the metalplate in one leven wit the tracks surface. Eventually paint. Worked fine in my case.

Regards Jens
Image
User avatar
Kellerkind
Posts: 35
Joined: Fri 29. Nov 2013 22:34
Location: Neustadt Southwest Germany

Re: Help !

Post by Kellerkind »

Hi Sylvain, I have to finish a second lanechange next days. I hope to add some pictures then and a "how to". Regards Jens
Image
Pussywagon
Posts: 29
Joined: Mon 25. Nov 2013 12:48
Location: Biscarrosse France

Re: Help !

Post by Pussywagon »

:bighand
Thanks!
User avatar
Keld
Administrator
Posts: 417
Joined: Thu 13. Dec 2012 19:06
Location: Copenhagen, Denmark
Contact:

Re: Help !

Post by Keld »

Pussywagon wrote:Hello!
In fact it is necessary to double the wire on 4 cm to replace lane change ?? Isn't it ? :roll:

Sylvain
Yes a little bit of double wire will do it. since the car always will go forward straight if you do nothing I made mine lane change laying the turn first and the straight next.
doing like this:


First I route the straight
mag1.png
mag1.png (1.04 KiB) Viewed 10948 times

Second I route the turn
mag2.png
mag2.png (1.58 KiB) Viewed 10948 times

Then I laying the wire to the turn (red)
mag3.png
mag3.png (1.61 KiB) Viewed 10948 times

and last i put the straight wire to continue in
mag4.png
mag4.png (1.59 KiB) Viewed 10948 times


lane change only done by wires :think

/Keld
Post Reply